Face Shape Comparison Guide
Round vs Oblong: Compare Your Proportions
Round vs Oblong: Compare Your Proportions starts with the outer line of the face, not with one feature in the middle of it. Put width beside length.
When two names both feel possible, one extra measurement is enough to separate them. The picture above is the pin for this guide. The same page is the link on the pins that belong with it.
Find Your Face Shape in Seconds
Not sure if your face is oval, round, square, heart, diamond, oblong, or triangle? Upload or take a clear front-facing selfie and MyFaceShape will analyze your facial proportions to help identify your face shape in seconds.
Simple face-shape analysis — not a beauty score or attractiveness rating.
Try MyFaceShape on iPhone or Android
How to read the outline
If you searched for “round vs oblong”, stay with the contour. Name the shape only after you can see where the face is long and where it is wide.
Round is the closer pair of measurements and a soft outline. Oblong is a much longer measurement with straighter sides.
Oval cheeks fit the same gentle curve as the rest of the face. Diamond cheeks are the widest feature, past both the forehead and the jaw.
Flip the width and you flip the shape. Heart carries width in the forehead.
When two names both seem possible
Triangle carries width in the jaw. They are the same taper turned over.
Square jawlines turn a corner and stay wide. Oval jawlines curve inward and finish narrower than the forehead.
The corner, or the lack of one, is the tell. Line up oval, round, square, heart, diamond, oblong, and triangle at the same size.
Compare the widest point and the length before you pick. Four lines cover a basic measure: face length, forehead width, cheekbone width, and jaw width.
Compare the three widths with each other, then length with the widest line. Length runs from the top of the forehead area to the chin.
Width runs across the widest part, often the cheeks or jaw. Which number leads splits round and square from oval and oblong.
Forehead width is the line across the upper face, above the brows and inside the hairline edges. Compare it with the jaw before naming heart, triangle, or square.
Cheekbone width is the line between the outer edges of the cheekbones, usually the widest middle point. If this line beats the forehead and the jaw, think diamond.
Jaw width is the line between the two jaw corners, not the chin tip. A wide result next to a narrower forehead fits triangle or square.
When you finish, you should be able to say which part of the face you used, not only the shape name. If two outlines both seem close, look again at the chin and the jaw corners. That is usually where they split.
Take the photo straight
Use one photo, taken straight on, with the camera at eye level. Hair only needs to be clear of the hairline and the jaw. A tilt, a shadow on one cheek, or a chin that is lifted will change the outline before you have even started.
Look at the forehead, the cheeks, and the jaw as three widths. Then compare the length of the face with the width. That is the whole reading.
Common questions
How do I use “Round vs Oblong: Compare Your Proportions”?
Put width beside length. If two outlines both seem close, look again at the chin and the jaw corners. That is usually where they split.
How do I use “7 Face Shapes Side by Side”?
Line up oval, round, square, heart, diamond, oblong, and triangle at the same size. Decide which area is widest before you say a shape name. The widest point is what starts the name.
How do I use “How to Measure Your Jawline Width”?
Jaw width is the line between the two jaw corners, not the chin tip. Clear the hairline only enough to see where the forehead ends. You are tracing a contour.
Find Your Face Shape
Take one clear, front-facing selfie and MyFaceShape helps identify whether your face is oval, round, square, heart, diamond, oblong, or triangle. Quick, simple, and focused on face shape — not beauty scores.
Try MyFaceShape on iPhone or Android